Electronic connectors

[Elad]

Cheers Chunks, nice one

[ChunkyMonkey]

Terry-Moto (20/02/2009)

ChunkyMonkey (20/02/2009)

Terry-Moto (20/02/2009)

ChunkyMonkey (20/02/2009)

Elad (20/02/2009)

kenny (19/02/2009)

Elad (19/02/2009)

Cheers Kenny, should be OK, as it is all standard original loom, I just snipped the original connectors off the end and am using those for the new headlights…

But let me know if that might cause issues

if you are replaceing rather than supplimenting should be ok although there are lots of threads out there that believe it gives a better light if you draw straight from the battery as there is less voltage drop, see how they look, if they are bright enough as is the jobs a good 'un maplins for the heat shrink and connectors by the way, and if possible then butt solder the wiring its less likely to give problems in the future.if crimping then you can get butt connectors with an integral water resistant grease for a better seal. maplins again I believe.

Cheers mate, will pick em up from maplins Had a quick test of everything and it all seems OK, only thing is the indicators seem to flash really quickly, which I believe is a common problem with aftermarkets… anyone know how to solve this one?

You need to add a resistor across the circuit. M&P or Busters should sell them:)

You know a lot about electric’s for someone that couldn’t wire his own headlight :D:) You been Googleing :Whistling:

Fugg off Mr Whippy. You mean the headlamp you was going to give me? I’m still waiting for it but got bored so i’ve bought one. I’ve bought a new loom now so don’t need your help either but I wouldn’t mind a 99;)

Thought you’d probably have a sweet tooth

At least I still have my own teeth