My micron downpipes turned up and my scorpion link pipe doesnt fit its a good 4mm too big. Without forking out loads for a custom link can i get mine made smaller in london?
How about a soft alloy tubed spacer with a slit cut in a diaganal way to make it snug with trial and error ???
like this
Attachments
Ah nice idea but i havnt got the time or materials to do anything like that was hoping someone would know of an exhaust specialist
dude you know you know one - youve even been to the unit?!??!!
I know but im always asking mark stuff and i know hes busy. I guess a nudge his way is needed then.
surely just a bit of tube stainless between will do the trick?
Car motor factors used to sell a length of stepped tube for just this problem. You just sawed out the bit you wanted and chucked the off cuts from each end in the bin.
Don’t know if you can still get them, but if you can, it may be an answer.
that’s what businesses are here for, you pay your money…