Ignore the instructions

Woke up on Monday to find i had a flat tyre!

Limped to the garage and pumped it up and had a good look but did not see anything (but it was dark)

Kept checking the tyre over the next couple of days and it was fine, until last night.

Finished work and jumped on to find it was flat again so i limped to the nearest garage which must have recently closed down so hunted for another.

Finally found a garage and got a can of tyre sealant/temp repair and read the instructions

REMOVE OFFENDING ITEM

So i did but it was a pretty big screw and i thought it odd to remove it.

Filled it up and limped to the next garage as the instructions said to ride for about 6 miles and then fully inflate tyre. By the time i got there the tyre was completely flat again.

I did manage to get home by limping from garage to garage but i am sure if i had just left the bloody screw in it would have been fine.

Moral of this long winded story is ignore the instructions and just do what feels right

Is it still possible to repair the tyre properly after using a sealant?

never heard of the 6mile thing? i’ve always just taken the nail/screw out, hooked up the canister and filled the tyre. it’ll sometimes bubble out of the hole left by the screw a little and then seal. i’ve had to make use of it quite a few times, and been able to leave it overnight with still fine pressure to ride to a garage in the morning to get the tyre plugged?

yep bat, if its the foam stuff its just a temp thing, the garage can wash it out (altho i’ve heard some can be funny about it - never had that experience myself).

the hole is more than inch from the side walls

not within an inch or two of another puncture repair

no more than two plugs in a tyre

mine poured out and left a big pile of the foam on the garage forecourt

Just think the hole was too big and i should have left teh screw in

Gotta think about how i get it to the repair shop now

nope the sealant will eventually eat the tyre walls (or so I have been told)

Bullsh!t!Tyreweld type stuff is water soluble and washes out of a tyre with warm water. I had a screw in a 1 day old car tyre and had to contact the British Tyre Association to prove to the tyre fitter that it could be repaired after using Tyreweld.

Thanks mate, good to know

Well thats good to know, they were probably just punting for business if my tyre went…

The tyre fellas do seem to say this go get you to buy a new tyre and of course washing it out is a bit messy;)

I’ve nicked this off the Holts site:

TYREWELD
Q. How does Tyreweld work? Is it a long-term measure?
A. Tyreweld is an aqueous latex emulsion, contained in an aerosol container, propelled by a hydrocarbon propellant. The latex emulsion locates the source of puncture, penetrates the hole, and cures to form a ‘get you home’ repair. This is therefore only a short-term measure and at the earliest instance the tyre should be repaired or replaced.

Q. Does this type of tyre repair cause unbalancing?
A. Tyreweld is a liquid formula and therefore spreads itself evenly around the tyre when driven, prior to it curing - therefore should not affect the wheel balance. Also as the car should be driven home at a moderate speed, minor effects on the wheel balance will not be observed.

Q. Can a tyre be repaired after the use of Holts Tyreweld?
A. Yes. Should the tyre be safe to repair, Holts Tyreweld can be flushed out of the tyre. Always follow the advice of the Tyre repairer.

Q. Is this product endorsed?
A. This is the only product to be endorsed by the National Tyre Distributors Association.

why do i get the feeling you jus spouted that from memory :blink:

I said I just nicked it from the Holts site.

If you look on the side of a can of Tyreweld there is a phone number for the British Tyre Association. That’s who i called when i had this problem.:cool:

Anyway,How are you getting on hopalong?:wink:

if its running out too quick, maybe rotate the tyre so its on the puncture and gets a chance to form a seal. or maybe put some electrical/gaffer tape round it whilst it setsor put the screw back in?

Im alright i took my ankle strap/support off today and ditched the crutches… i then walked to the Barbers and got myself a much needed haircut. :smiley: My elbow is still giving me short sharp reminders its still not 100% but ill soldier on