Honda CBR600 (Steelie)
Ex-Sanyo motor, gas flowed head, Kent Cams (Hon14), 1mm over size pistons, total loss ignition, machine clutch, K&N air filter, Ram air box, Full Akrapovic Exhaust, Ohlins re-valued and sprung forks, Ohilns rear shock, EBC Pro-Lite discs, EBC pads, Braided Lines, FireBlade front mater cylinder, 5.5inch rear wheel conversion (to fit 180’s), 14000 rpm CDI, large battery conversion, Spondon Oil Cooler, Elliot Tacko.
The engine has just had a re-fresh, is not run in and has not been raced since.
It has been raced with Derby Phoenix MCC for the last 3year and is a top five finisher. A full invoice history is with the bike.
If you require any additional info please call Mark on 07760 173671 or 01427 880 720 after 6pm.
The reason for selling is that I have just negotiated a sponsorship deal that comes with a bike.
The bike £1,300.00
The bike and the first lot of spares £1,700.00
The lot 2k
1x Spare motor (1996yom)
1x Wets on wheels (5.5 inch rims), with discs.
1x Inters on wheels 95.5inch rims), with discs.
1x Set of bodywork
1x Standard 5.5 inch blade rear wheel.
1x Standard Steelie rear wheel with tyre (dyno setup wheel)
1x Generator cover.
1x Pickup cover + pickup.
1x Clutch cover.
1x Set of rear sets (New)
1x Front fairing brace (New)
2x Clip on’s (Odd)
1x Front break master cylinder.
2x Front sprockets (15/16 teeth).
1x Box of assorted oil cooler seals.
1x Box of assorted engine gaskets.
1x Clutch cable.
2x Throttle cables.
3x Sets of race plugs (Ro045Q-10)
1x Box of assorted electrics.
1x K&N air filter.
1x Standard CDI
1x Cush drive.
1x Used clutch.
1x Box of assorted fasteners.
1x Battery.
3x Oil filters (new)
1x Set of Kent Cams (Hon 14)
1x Water Pump.
1x Crank and shells.
1x Clutch assembly.
1x Gear box.
3x Con rods including shells.
1x Set of machined pistons (standard size)
1x Spare battery
Also to go:
1x Engine: Nicky Kennedy Tuned, HRC KC Hon 11 cams, Flowed Head, Polished Casings (inside), Total Loss Ignition, Machined Clutch Gear, Balanced Crank.
1x Engine: Nicky Kennedy Tuned, Joy/re-profiled cams, Flowed Head (the head is off and has been refreshed), Total Loss Ignition, Machined Clutch Gear, Balanced Crank.
2x Standard Wheels (Rear).
1x Sprocket carrier.
1x Clutch cover.
2x Water pumps.
2x Top hose mountings (thermostat covers).
2x Gear boxes.
1x Clutch assemblies.
1x Pair of lower fork stations.
1x Pair of front callipers.
1x Rear brake calliper mounting bracket.
1x Fly wheel assemblies.
2x Cranks.
1x Set of front fork springs (standard).
1x Rear rising rate linkage.
1x Throttle assembly.
2x CDI units (14000)
2x Damaged repairable flowed heads (Hobb Sport and R&S Performance).
3x Standard oil coolers.
1x Engine cover (ignition side).
1x Oil pump.
